Velodyne DD-12
Verstärkerplatine — repariert.
Velodyne closed years ago, so a dead Digital Drive DD-12 has nowhere official to go — and these are premium subwoofers with driver and cabinet quality that's genuinely worth saving. Most failures trace to aging electrolytic capacitors on the power and DSP boards; one specific fault (a failed DSP chip) is not repairable at all, and we'll tell you honestly if that's what you have before quoting anything.
Ist es wirklich die Platine?
Diese Fehlerbilder sehen wir beim Velodyne DD-12. Finden Sie Ihr Symptom, bevor Sie einen Cent ausgeben.
- Completely dead — no power, no standby light at allPLATINE — WIR BEHEBEN DAS
The mains fuse is usually still intact on these units. The far more common cause is that the power supply's main filter capacitors have dried out with age and the unit can no longer start up at all.
- Squealing or loud humming noise from the DSP control board on power-upNOT REPAIRABLE — DISCONTINUED CHIP, NO FIRMWARE AVAILABLE
This traces to the digital signal processor chip on the input/control board. Velodyne never released the programming data or firmware needed to program a replacement chip, and the company no longer exists to provide it — so even sourcing a physically identical chip does not restore function. We'll confirm this diagnosis before you pay for anything.
- Visibly bulging or leaking capacitors on the power supply boardPLATINE — WIR BEHEBEN DAS
These units are now 15-20 years old, and the electrolytic capacitors on the power and processor boards are well past their design life. Leaking electrolyte is mildly corrosive and can eat into nearby traces if left too long, which is why this is worth addressing even before it causes a hard failure.
- Distorted, crackling, or "motorboating" static noise during playbackPLATINE — WIR BEHEBEN DAS
The same capacitor aging that causes bulging elsewhere on the board also degrades the amplifier output stage's filtering, producing a rough, distorted, or engine-like static sound rather than clean bass.
- Intermittent rattling or buzzing noise that sounds like a blown driverPLATINE — WIR BEHEBEN DAS
This is easy to misdiagnose as mechanical driver damage, but the DD-12's servo-feedback amplifier board is the more common actual cause — professional repair technicians who service these units consistently trace this exact symptom back to the amp board, not the woofer.
- Ports noise / rattle only at specific bass notesUSUALLY MECHANICAL
Check for loose grille screws, port debris, or objects near the cabinet resonating before suspecting the electronics.
Warum die Originalplatine ausfällt
Velodyne's Digital Drive series packed a lot of engineering into a subwoofer: a servo-feedback amplifier board and a separate DSP-based input/control board built around a Texas Instruments processor. Both boards lean heavily on electrolytic capacitors, and these units are now well into their second decade of service — capacitor aging is by far the most common thread running through every failure mode we see, from a unit that won't power on at all, to distorted or "motorboating" sound, to a rattling noise that owners often (and understandably) mistake for a blown driver.
There is one important exception: a squealing or humming DSP board points to the control chip itself failing, and Velodyne never published the firmware or programming data needed to bring up a replacement. With the company no longer in business, that specific fault has no repair path — component-level or otherwise. We diagnose your unit fully before quoting, so if that's what's wrong we'll tell you plainly rather than charge you for an attempt we already know won't work. Every other common DD-12 fault, including the capacitor-driven ones, responds well to component-level repair.
Einsendereparatur für dieses Modell
Noch keine standardisierte Platine — aber unsere Werkbank repariert diese auf Bauteilebene, getestet und zurückgesendet.
- 01 Reparaturformular mit Symptomen und Fotos absenden
- 02 Wir bestätigen die Reparierbarkeit und senden unsere Adresse — Sie verschicken nur die Platine
- 03 Werkbank-Diagnose, Festpreis per E-Mail — keine Reparatur, keine Kosten
- 04 Repariert, getestet, zurückgesendet — Rückversand übernehmen wir
Fragen von Besitzern
Velodyne doesn't exist anymore — can this actually be fixed?
For most failures, yes. The majority of DD-12 faults are aging electrolytic capacitors on the power and amplifier boards, which is standard component-level repair work that doesn't require anything from Velodyne. The one exception is a failed DSP chip on the control board — Velodyne never released the firmware needed to program a replacement, so that specific fault genuinely has no fix, and we'll confirm honestly if that's what yours has before quoting.
My sub makes a rattling noise — is my driver blown?
Possibly not. This exact symptom is a documented DD-12 amplifier-board fault that sounds like a mechanical driver problem but usually isn't. Worth a bench diagnosis before you write off the driver.
Is a subwoofer this old still worth repairing?
The Digital Drive series was Velodyne's flagship line — the driver and cabinet engineering hold up well, and most faults are inexpensive capacitor work. It's usually a strong candidate for repair rather than replacement, especially since there's no current equivalent from the (now-defunct) brand to buy instead.